How to Weave With a Pin Loom

Weaving on a pin loom is easy and fun–once you know how to do it! If you’ve ever wanted to know how to weave with a pin loom, this tutorial has everything you need to know! Once you get comfortable with this method you can change it up and weave using different yarns for warp and weft, using different yarns for each layer, or weaving with two thinner yarns used together.

How to Weave With a Pin Loom 

When you warp a pin loom, you’re actually laying down three layers—two warp, one weft. You’ll use a long needle to weave in the fourth layer, the second weft layer that will lock everything in place.

Remember while setting up a pin loom that loose tension is essential for a successful weaving experience.

Start by securing the yarn to the loom with a knot, a piece of tape, or a slot in the loom. Leave a 6” tail so that you can weave it in later. Notice that the pins on this loom are grouped in sets of 3 or 4. The first move is to bring the yarn to the left of the set of 4 pins on the lower left.

Little215356

Warp 1: Bring it around the 2 pins on the upper left, between pins 2 and 3 on the lower left, and up between pins 1 and 2 at the top. For the rest of this layer, you will go between pins 1 and 2 and around 3 on both top and bottom.

Little215357

When you come to the top right corner, turn toward the bottom between pins 3 and 4, then between 1 and 2 at the bottom. Weft 2: Turn the corner, wrapping around both pins on the bottom of the right edge. Cross to the left edge, passing between pins 1 and 2.

Little215359

Continue going between 1 and 2 and around 3 until you reach the top left corner and pass between 1 and 2. Warp 2: Turn the corner and go between pins 1 and 2 on the upper left. Notice that you’re passing between two pins that have been wrapped around on the Warp 1 layer. At the bottom, pass between pins 1 and 2.

Little215360

For the rest of this layer, go around pin 1 and pass between pins 2 and 3. When you reach the bottom right corner, go around pin 1.

Little215361

Wrap: Use the loom itself as a tool to measure out the length of yarn needed for the second weft pass. Beginning at the bottom right corner, wrap the yarn around all the pins 5 times and cut.

Little215362

Weft 2: Thread the measured-out yarn on a long weaving needle. Bring the needle between the bottom 2 pins on the right edge, over the loop on the outside of the pins and under the first warp thread. Continue weaving over and under across the loom, bringing the needle out below the lowest pin on the bottom edge.

Little215364

Wrap around the bottom peg and bring the needle over the loop outside the pins on the left edge, under the first warp thread, and continue across. Repeat until you reach the top left corner. Weave the last pick by wrapping around the two top pins on the left edge and weaving across. It is essential to weave the last pick—it locks the whole piece in place.

Little215365

Weave in the starting and ending tails and pop the square off the loom.

anne.jpg

PS: For more information on pin loom resources and what to do with your squares, check out our Pin-Loom Resource Page!

Other items you may enjoy:

Categories

Small Looms
Christina Garton

About Christina Garton

I'm Associatet Editor for Handwoven where I get to interact daily with all sorts of wonderfully creative people. I'm obsessed with twill and weaving dishtowels, although I'm also in love with deflected doubleweave. When I'm not weaving twill towels, I love to try out new fibers and structures and blog about it as I go!

Comment